When I attempt to run Crystal Control v0.93 on my copy of Windows NT 4.0 SP6a, I receive the following error when it launches.
"The procedure entry point RtlStringFromGUID could not be located in the dynamic link library ntdll.dll"
I have no LCD display to connect to the unit, but I was trying to view the software to see what uses I might get from an LCD. However, I can't even get into the problem far enough to configure an LCD even if I had one connected.
The file ntdll.dll on my system is dated 18 Nov 1999, could this be out of date?
"The procedure entry point RtlStringFromGUID could not be located in the dynamic link library ntdll.dll"
I have no LCD display to connect to the unit, but I was trying to view the software to see what uses I might get from an LCD. However, I can't even get into the problem far enough to configure an LCD even if I had one connected.
The file ntdll.dll on my system is dated 18 Nov 1999, could this be out of date?
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.