Hi, i need a little guidance with setting this equipment up. I ordered the 635, SCAB and Y14 cable all together at the same time and i want to set it up on my Linux machine.
The first thing i want to enable is ATX power
on/off & reset. Unfortunately i'm a bit challenged when it comes to even connecting this thing up.
The SCAB is preconnected to the 635 with a short cable and i think the J8 and J9 jumpers
on the SCAB are preset properly for ATX power control.
So, am i correct in assuming i need to connect
the USB cable to back of 635 and the Y14 cable to J8 on SCAB?....just those two cables yes?
Thx for any help.
The first thing i want to enable is ATX power
on/off & reset. Unfortunately i'm a bit challenged when it comes to even connecting this thing up.
The SCAB is preconnected to the 635 with a short cable and i think the J8 and J9 jumpers
on the SCAB are preset properly for ATX power control.
So, am i correct in assuming i need to connect
the USB cable to back of 635 and the Y14 cable to J8 on SCAB?....just those two cables yes?
Thx for any help.
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.