Vista Error Message

jaytx

New member
I am attempting to install a CFA 632 serial using Window Vista and CC106. I get an error message " Access violation at address 00470D63 in module 'Crystal Control.exe' read of address 00000154" when I attempt to add a new screen. Board is an ASUS K8N, module is on com 1 and boots normally. How do I correct this?

Thanks

jaytx
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

CF Mark

Administrator
Sorry, CrystalControl1 is now unmaintained and has been for some time.
If you are having problems with it, there isnt much i can do.

I suggest you try CrystalControl2.
 

jaytx

New member
Went to CC2 still a problem

I did dump CC1 and am installing CC2, however following insall and changing .exe files in compatibility mode per instructions i now get an error 'could not start the CC2 service. Unknown error (2)' This is with a CFA-632 serial display. I can get CC2 to work once I restart the computer. But I have to do this for each screen I load or change. Each time iI try to restart service I get the same error message

Thanks again,

JayTx
 
Last edited:
Top