I have a TM12864A2FFG displayer , with the SED1565 controler ,the problem that i can't obtain the -9.5V when i applied the power supply circuits :
-> Booster circuit control bit :ON
-> Voltage regulator circuit (V regulator circuit) control bit ON >Voltage follower circuit (V/F circuit) control bit ON
but when i applied the Booster circuit control alone i have the -9 V
the Circuit is : 3X charge pump, 4.7uF between CAP2+ and CAP2-, CAP1+ and CAP1-, and Vout connected to CAP3- and through a 4.7uF capacitor to VSS.
for more information of the circuit see this site :http://www.tianma.com/admin/specification/425TM12864A2FFG.pdf
my circuit is when the voltage regulator internal resistor is not used
thanks for help
-> Booster circuit control bit :ON
-> Voltage regulator circuit (V regulator circuit) control bit ON >Voltage follower circuit (V/F circuit) control bit ON
but when i applied the Booster circuit control alone i have the -9 V
the Circuit is : 3X charge pump, 4.7uF between CAP2+ and CAP2-, CAP1+ and CAP1-, and Vout connected to CAP3- and through a 4.7uF capacitor to VSS.
for more information of the circuit see this site :http://www.tianma.com/admin/specification/425TM12864A2FFG.pdf
my circuit is when the voltage regulator internal resistor is not used
thanks for help
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.