Init of com 7 failed

ortho

New member
I just purchased a Model 632 USB and followed the instructions to load the USB driver. The driver loaded OK and the unit lighted up with the cursor blinking. I loaded the Crystal Control software and added the 632 to the list. I went to my Windows hardware profile and it says that the Crystalfont USB driver it is on COM 7. When I set the Crystal Control software to COM 7 and hit test I get and error message that "init of COM 7 failed". This is my first experience with CrystalFont so I am not quite sure where to go from here. Can someone help?

Nevermind! I got it fixed. It might help to reboot. Daah :)
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 
Last edited:
Top