junior_1967
New member
Hi All,
I just ordered a 635+SCAB+ATX power connection.
I read in the SCAB datasheet that GPIO1 to GPIO3 are taken for ATX control.
Can one still use GPIO0? The reason I'm asking is that it appears that the plug of the ATX cable covers the GPIO0 pin but is unpopulated. I was planning on using it to drive a relay to turn my CCFL on or off.
Thanks
I just ordered a 635+SCAB+ATX power connection.
I read in the SCAB datasheet that GPIO1 to GPIO3 are taken for ATX control.
Can one still use GPIO0? The reason I'm asking is that it appears that the plug of the ATX cable covers the GPIO0 pin but is unpopulated. I was planning on using it to drive a relay to turn my CCFL on or off.
Thanks
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.