• We recently switched our forum platform. If you experience any issues please email support@crystalfontz.com

634 Usb

PyroTeknik

New member
I installed it right according to the instuctions appearing every few posts..... i downloaded drivers before install and then installed the device point it to the folder..... it has its own com port (COM3) it seem to work... but as soon i load crystal control it freaks out.... starts doing matrix code but horizontal........ any ideas what it is???
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

PyroTeknik

New member
set it it 19200 and it worked DOH! you should put that in your instructions that you post ot everyone whoever posts it
 
Top