i have had the 632 in my pc problem free for a month or so... my pc bluescreened a few nights ago and when i restarted i got an error code as follows in w2k sp2:
-----
error
init of "com1" failed.
the module will be disabled until it is reconfigured.
----
i get the crystal fonts boot screen on the lcd and the backlight works fine... after i get this message i only get a blinking cursor top left of the screen.
i have reinstalled the drivers for the com port and tried all settings - hardware and software (w/ reinstallation of crystal control)...
any suggestions?
-----
error
init of "com1" failed.
the module will be disabled until it is reconfigured.
----
i get the crystal fonts boot screen on the lcd and the backlight works fine... after i get this message i only get a blinking cursor top left of the screen.
i have reinstalled the drivers for the com port and tried all settings - hardware and software (w/ reinstallation of crystal control)...
any suggestions?
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.