How to configure CFA633-YYB-KS for reseting the system

[jaggajat]

Hi all,

I have this LCD CFA633-YYB-KS. wiht ATX connector wiht two cables Power and Reset. I want to use the keys on the LCD to Reset my server. Any hints how I can do this.My Motherboard is Tyan S5102.

Thanks in advance
Aman

Crystalfontz LCD Blog

Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.

 

[CF Tech]

In general terms, you can look at the CFA-633 data sheet in the section on ATX POWER SUPPLY CONTROL CONNECTIONS starting on page 8, and 28: Set ATX Power Switch Functionality starting on page 35.

If you have a more specific question, please post back.

 

[jaggajat]

Hi

Well I went through the Doc and didnt get any luck. Basically I am hooking the cable from the ATX connector to the reset pin on the MB. Then I try all the keys nothing
Any ideas what is going on.

A

 

[CF Tech]

Did you send command 28, and store it as the boot state?

 

[jaggajat]

Yes I did, still nothing. Could I have steps that I need to follow from the connectors to final setup.

Thanks

 

[CF Tech]

When you hold the green check key for 4 seconds, does the display momentarily show "Power On" or "Reset"?