Hi,
I interface CFAL12832DB OLED display with my STM controller ,
I followed the information given at file:///C:/Users/night_Owl/Downloads/CFAL12832D-B_Series_Datasheet_Release_2016-04-28%20(2).pdf
The SCLK is 1.25 Mhz and I used 4 Wire Spi Configuration.
8 bit - MSB First, Clock Polarity high and 1 Clock phase -1st edge.
I copied these files from the example codes given in the website,What could be going wrong in this?
Regards,
Joe
I interface CFAL12832DB OLED display with my STM controller ,
I followed the information given at file:///C:/Users/night_Owl/Downloads/CFAL12832D-B_Series_Datasheet_Release_2016-04-28%20(2).pdf
The SCLK is 1.25 Mhz and I used 4 Wire Spi Configuration.
8 bit - MSB First, Clock Polarity high and 1 Clock phase -1st edge.
Code:
SPI_Init();//SPI Init
HAL_Delay(60);
reset_display();
HAL_Delay(60);
init_OLED();
while(1)
{
show_bitmap(0); // display image0
HAL_Delay(6000);
show_bitmap(1); // display image1
HAL_Delay(6000);
}Regards,
Joe
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.