633 reset to defaults

potscrub

New member
Newbie here,
My 633 wont send a return packet when I press any of the keys on the keypad. What have I done??
Cheers
Rob
NZ
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

CF Tech

Administrator
You have probably turned off the key reporting.

Use command 23 to re-enable key reporting by sending the following data:

\063

Then you will want to save that as the boot state, using command 4.

Please refer to the 633 data sheet for more details.
 

potscrub

New member
I get this error when using this command in wintest
C=23(23 = Set Key Event Reporting),L=1,D="?",CRC=0x1FF0

Error
C=215(Error: Set Key Event Reporting),L=0,D="",CRC=0x411D74

How did you know what data to put in c=23. What does \063 stand for? Is it Binary, decimal, ascii?
Thanks
Rob

Update: I put in \049\063 which D= 0? and that worked, What does the ? stand for?
 
Last edited:
USB LCD Displays - Graphic and Character LCDs with a Keypad
Top