Optrex F-51553 Display Problems

.
.
Andrew, are you sure you want to hijack pcproa's thread, instead of starting your own :confused: ??
... the code a number is shown in brackets that does not seem the relate to the control
code. How do the two relate?.
They are probably not related in any important way.
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

andrew99

New member
cosmicvoid,

Not trying hijack anything. I thought the discussion was relevant to the topic
of the post and the examples provided. If the person who originally started the
post has an issue with the discussion should not he/she point that out.

Sorry if I stepped on any toes but again the questions are relevant to the examples.

A
 

elar

New member
Backlight terminals

What are you using to connect to the backlight terminals? I am trying to find something better than bare wires.

Thanks
 
FYI, I use insulated wires to a 2 pin connector, only because I was unable to think of a connector that could go directly between the B/L pads and the pcb. In my case the area directly under the B/L pads is populated on the other side of the pcb, so I would need a SMT connector, and the clearance is just too small.
 
Top