Problem with Phillips LCD driver chip PCF8576

nzkb

New member
Hi,

I am trying to use a PCF8576 to drive an LCD. I can write a 16 byte packet to the driver succesfully via the I2C bus as there is an acknowledgement bit sent by driver after recieving every byte.

The 16 byte packet consists of:
01110000 Slave Address
11100000 Device slelect define device sub-address
01001000 Mode set define LCD drive mode 1/4, LCD bias config 1/3, enable LCD
11111111 Display byte 1
...
...
11111111 Display byte 13

The problem is there are no waveform on the backpland or segment output pins.

Any help or torubleshooting advice would be much appreciated.

Thanks,
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

chrisyard

New member
Hi

I know this is an old post, but did you get yours to work ???

I have this IC and I did get it to work but have found other problems with it.

I will start another post if you have resolved it

thanks

Chris
 

rbo

New member
Hi chrisyard,
i have exactly the same issue as nzkb. Did you get the chip to be working ? i.e any pulses output from the PCF8576?

cheers
 
Top