CFAG320240C-FMI-T to parallel wiring issue

jamone

New member
I've tried what I think the wiring should be based on the CFAG_WinTest for my model's source says, but some pins arn't accounted for and my image, stays blank, although it does flicker and change slightly depending on the test pattern I send it.
Pin 6 on the LCD is labeled by A0, I don't see where I'm supposed to hook that, but it seams important by the datasheet. What am I doing wrong?
Looking for additional LCD resources? Check out our LCD blog for the latest developments in LCD technology.
 

roubic

New member
answer

i agree with homelessgiant
A0 is the same as RS from the code comments, so connect A0 from the LCD to pin 16 on the PC.
 
Top